BennyModz Nerf Longshot Breech for BrassBreech

thingiverse

This design is inspired by fléchette spectre. I design this as I'm using a 0.6 nozzle diameter, this model is able to print with a 0.4-0.6 nozzle as the walls are thicker. Maybe slightly stronger? This Breech design is able to fit in aluminium plungertube, the back part has the outer diameter of 33.9mm. Breech is meant to fit in 19/32 brass size. This set up will be much easier to build a brass breech. Unlike back then everyone has to cut the nub and glue on the brass which is a hassle. You can use longshot stock oring. But you need two of them. ●●●●●●●DO NOTE●●●●●●●● 1. If the model appears to be big in your slicer scale down to from 100% to 10%. That means your new scale will be 10% 2. To print this it will be better to use cura slicer, as the 100% will covered everywhere. I'm not sure about other slicer but cura is the only one I used.