BETA BlockStock GunStock Vr with shotgun mod

thingiverse

This Project is for normal to advanced 3d printer users and need a wells calibrated printer! [Read all the instructions and send me feedback if you run into any issue or have any idea to upgrade the model, I respond fast I even have a discord server if you want to participate to one of my project] Note that you may need to download each file indidualy... This gunstock work very well and its very light with the freehand cup that make you reload fast crazy and with pump shotgun its feel amazing! You have 2 option: free bolt one if you don't want to buy bolt, but you feel a little on flex in or use M5x30mm you need 8-10 depending on the setup They are 4 pieces(1-4g part) that you may need to scale up or down for fitting depending on the resulting print quality of the main part : Top Clip, Bottom Clip, Middle Rail Joint, 30 mm plastic nail. To mount 2 rails together, You need to put the middle rail joint first in the middle of the 2 rail, secondly put the bottom clip on the 2 rail, finally put the top clip on the top of the 2 rail The shotgun mod work by putting a rubber band between the mod and the rail adaptor and adjusting the position of the mod for shorter or longer shotgun. The button is the piece that stop the rail adaptor from moving, it is recommended to put a rubber band there too The shotgun pin is the piece that make the connection between shotgun mod rubber band and the rail adaptor, they have also the ability to make the adaptor slide when putting the button on the shotgun pins For the sling they are holes everywhere, so you can pretty have it exactly where you want If you want an All-in-one solution for maximum in game compatibility, use the same stock and controller angle position as the one of the picture (stock in the middle angle, dominant controller on the middle angles, and the secondary angles on the third angles)