Bike Bottle Holder

prusaprinters

<p><strong>A bike bottle holder for your standard 0.5l PET bottle. The holder is designed with harder use in mind and therefor not too thin.&nbsp;</strong></p><p>There are two different versions. One with slots at the side and one without them.&nbsp;</p><p><i>Check the measurements to find out if your bottle and bike will fit.</i></p><h4>Measurements:</h4><ul><li>height: 129.5 mm</li><li>diameter of the hole: 69 mm</li><li>diameter of the frame: up to 33 mm</li><li>screws: M5</li></ul><h4>Print Settings:</h4><ul><li>Supports: <i>(usually)</i> no</li><li>Raft: doesn't matter</li><li>Walls: 3&nbsp;</li><li>Infill: at least 20%</li><li>Material:&nbsp;<ul><li>PLA works</li><li>PETG or ABS/ASA might be even better</li></ul></li></ul><p>About the slots:</p><ul><li>They make the print a bit lighter. But also a bit less sturdy. They can also increase the print time, as the supports that are needed if you choose the version with the slots on the side may take a bit longer to print.</li></ul><h5>About v3</h5><p>I changed the mounting mechanism, so it can fit different spacing between the holes in your bike frame. I also made the slot's diameter a bit wider, as the screws fitting were very tight.</p><p>&nbsp;</p><p><i>If you are interested in a different size or other changes, just leave me a message and will see if I find time to make it.</i></p>