Bike Handlebar Shim for Brake Levers

thingiverse

This is a shim designed for adapting brake levers with an I.D. of 23.8mm to a handlebar with an O.D. of 22.2 mm. Two shims will need to be printed for each brake lever. I added ridges to either end of the shim so that it wont slip out over time, and to make it easier to install. I specifically designed this for my Tektro brake levers so the groove that fits the clamp is 17.5 mm thick. V2: The edges are now half as wide to save on material. You could probably even make the edges even smaller if you wanted to. V3: After printing and installing on my bike, all of the edges broke off because where they connect to the shim is very fragile. I removed the edges in this version.