Biltema pegboard Ryobi sander pad holder

thingiverse

This is designed to be printed with 0.42mm line width! If you are using 0.4mm nozzle, then 0.42 is coming out great and making strong prints! I needed something like this and I started remixing this: https://www.thingiverse.com/thing:2891163 But after it was done, I noticed it would take 48 hours to print and use 207 meters of filament (617 grams). That was waaaay too much, so I designed new one from ground up. My holder takes only 14 hours to print and uses 55 meters of filament (164 grams). But it is not weak, it has 8 walls in front and back and 4 walls in each section walls and 7 layers in the bottom. Also included is 3mf -file, so you can open this in Microsoft 3D Builder and easily change wall locations, numering and screw hole locations. Holes are set for Biltema pegboard, put you can screw this to any surface, holes are 5mm in size.