Bimini Cover Brackets

thingiverse

Designed these to be used with 25mm Aluminium poles, Designed to be used with Bowline Bimini covers, but will fit any Bimini covers using 25mm poles. I have also built a solar panel frame out of 19mm square tube, which is mounted on top of my Bimini, So I have added those too, I will add more as I make/need them. If there are any you would like, send me the specs and I'll design and add them here. Print settings I commonly use with PETG are below, my setting probably wont work for everyone but just thought id throw them in there as a guide. Print Speed - 50mm/s Infill Speed - 50mm/s Outer Wall Speed - 30mm/s Inner Wall Speed - 40mm/s Travel Speed - 120mm/s Initial Layer Print Speed - 25mm/s Enable Retraction Retraction Distance - 7mm Retraction Speed - 25mm/s Nozzle Temp - 145 Bed Temp - 40 Print with Brim