Bird Spikes for Wyze Outdoor Cam

thingiverse

Bird spikes for Wyze outdoor cam. I made this to keep the birds off of my Wyze outdoor cam. I utilized two other designs to make my design using Tinkercad https://www.thingiverse.com/thing:4740505 https://www.thingiverse.com/thing:4484142 You can print this out three ways. Print the hood and spikes sized for the hood separately and then glue the spikes on top of the hood. This way you do not need any support as you can print the hood upside down. You can print out just the spikes for the cam only and glue it on the top of the cam or you can print it in one piece with support but it will take a bit longer. I hate it sometimes when getting the support out is a pain in the butt. Files: Lid Only Use with spikes for lid and glue spikes on top Spikes for lid Use with Lid only and glue on top of spikes Spikes for camera Glue directly on top of camera, no hood needed One Piece Print in all one piece, but use supports I did this with standard Cura settings and I used 10% infill. You can bump up the infill to anything you want. The hood should fit on nice and snug, if not a drop of hot glue, or double sided tape will keep it on. I used Solutech PLA Premium as I live in SW Florida where it gets hot in the summer. If you live in the heat and put this in the sun like me, you might want to print with a stronger material if your into that. But PLA is fine.