Bitcoin To The Moon

thingiverse

These printed with no problems at all really. The top I printed twice as I printed it way too fast the first time and it looked messy. Just used Cura for our slicer with a 0.2mm Standard Quality heated Bed @ 60 Nozzle @213 with 0.4mm nozzle. nothing crazy. Rocket-I printed the Rocket with Zero Infill and support only under the 90 degree part of the 3 legs. Smoke- I Printed with 10% infill to give it a little weight and help pick up the center of the smoke and 100% at the tip to help with load of Rocket. Probably did not need that. Flame- I printed with 100% infill as it was a connector piece and not much to it. Probably could print with 0% infill. Top- I Printed with 0% infill, and slowed it right down for the needle. Top with Threads- printed with 20% and small support but with the bridging setting in Cura probably needed no support.