Bittboy L/R SMD Push Button Holder and Cap

thingiverse

I've had bad luck using zdanee's holder, maybe the buttons I've had were too thick, I just couldn't fit it in the case. I've redesigned the thing to use a pair of my SMD push buttons. I've tried it to keep it as far away as I can from the processor. I've used enamel copper wire long enough so I can take it apart easily. They were threaded through the slots on the piece before I've soldered them. The button is kept in place using adhesive putty, since it's a flexible and I didn't need anything strong. The cap is very hard to remove from the printing bed. I've lost a button, because it flew away as I was prying it, I've found it months later. The bracket printed fine for me without any support or raft or anything.