Blade Inductrix FPV and FPV Pro Case

thingiverse

UPDATE Feb 24, 2018: I finished the carrying case, check out this Thingy https://www.thingiverse.com/thing:2814692 NEW AND IMPROVED, and some additional options. PLEASE NOTE: I have uploaded an FPV Plus version of the case here: https://www.thingiverse.com/thing:2801903 I have completely re-worked the files, and optimized for printing. I did a true offset, so now the round corners are parallel. The walls are now 1.6mm or 3.2mm thick, and if you print with 4 shells, they will print solid, and not use infill, which makes them print faster. I have made a few different versions. I like the thicker walled version, but was also asked to make a thin walled version, which works really well, and reduced print time by more than an hour and a half on my printer. Here's an explanation of the different versions. V22 FPV Bottom Thin Half Bat - Thin walled version with battery holders only 1/2 way up. This is enough to hold the battery in place, but further reduces print time. Also made the battery holders a little wider, to hold thicker batteries. V22 FPV Bottom Thin - Thin walled version without battery holders. This on my printer takes less than 3 hours to print. V22 FPV Top Thin Lip - New version of a Low profile top, to be used with above version without battery holders V22 FPV Top Thin Lip Bat - Taller version of the new lid, for the bottom using the 1/2 height battery holders. V22 FPV Top Thin Lip Tall Bat - Extra tall version of the new lid, for those who want to print the bottom with the battery holders like sebsx, who have really tall batteries. I have now uploaded the thicker walled versions, with are 1.6mm and 3.2mm thick. The lids have a 10mm overlap, which makes them fit really snug. I like the thicker walled versions for stand alone cases the best, but the thin wall work just fine, and print, much, much faster. Enjoy. This is my take on a carry case for an Inductrix FPV. Design similar to by RockstarAlchemist and babar121 http://www.thingiverse.com/thing:1580567 http://www.thingiverse.com/thing:1637219 However, I made this from scratch in Fusion 360. What I found when I printed the versions above, was for my FPV, the fan cowlings hit the battery compartments. And I really has to press it in, and I worried about warping the fan cowlings. Also the spots for the motors didn't quite line up for mine. So I just redesigned it to make a little more room. Also, no logos, no fillets for the top and bottom so it prints easier.