Blade Runner PKD Blaster Stand - led lights & reversible

thingiverse

Lighted stand for PKD Blaster. Stand is in sections so you can swap the ends and display blaster in either direction. 2 5x5mm magnets hold the bottom led cover in place. 1 5x5 magnet is in the top of the pole to hold to bold in base of barrel. 3mm LED's x 4 One 2032 lithium battery. LED's bought on amazon ( 3mm and 5mm Diffused LED Light Emitting Diode Assortment Kit - Pack of Assorted Color Diffused LEDs (310pcs) and Resistors - Red, Yellow, Green, Blue and White LED Indicator Lights - Brand: Plusivo ) Magnets bought on amazon (brand promage - 80 Pieces 5 x 5mm (1/5 x 1/5 inch) Tiny Round Disc Small Multi-use Refrigerator Magnets) Used a single 6mm slide switch - bought on amazon as a 20 pack (uxcell® uxcell20Pcs 2 Position 3P SPDT Panel Mount Micro Slide Switch Latching Toggle Switch) You are going to daisy chain all the led's together. I just used a white wire for both making note of which was positive. If you have red and black wire use that - red to all the long ends of the led's and black to all the short ends of the led's. Wire the long end (the positive + aka red) of each led to each other and do the same for the short wire (the negative aka the black) The + battery connects to the first + red wire led. The - battery connects to the end (either end) of the switch. you then run a new wire section from the middle connection of the switch to the first led - negative black wire. Best to solder them and put a little electrical tape on connections to avoid shorts. If that doesn't make sense, check out the picture uploaded :)