Blinds rod end part

prusaprinters

I broke my blinds. I fixed my blinds. This fits into the 1/4" hole where the plastic part that hooked to the turning mechanism broke. I just super glued this part in. If it breaks again, I can just snip it off and glue in a new one. This file will print two end pieces. The prints will be better quality by printing two at a time, since it is so small. It only takes about ten minutes total, so no big deal. I printed at .20mmlayer height, 3 perimeters, tops, and bottoms. No support needed. Print as oriented in the file. Category: Decor