block and tackle 8 parts

thingiverse

this is a block and tackle i designed so that i could lift things easily around my shop. I printed the parts that will be handling the main part of the load at 100 percent infill. Everything else was printed at 50% honeycomb infill. For the complete set up, of 8 parts of line you will need 8 pulley wheels, 7 outer walls, 2 attachment points, 1 outer wall tie off, 1 becket body, and 1 inner becket. if you need more or less, ive attached a link to how to reeve the system. Here is a link on how to load the line into the system. it will be on page If you print this, you assume all responsibility if it fails, and it is not my liability. https://www.manitowoccranes.com/~/media/Files/Crane%20Care/Reeving_Information_v2.pdf HARDWARE: 1/8 inch paracord 6 sets of 5/16 x 4 inch bolts, washers, and nuts 8 sets of 608 skate bearings (6 x 22 x 7) 1/8 inch cable clamp 1 3/4 x 1 inch bolt 1/4 inch shackle 1 hook