BLTouch mount for HyperCube (Updated Mounting)

thingiverse

I built a custom mount for my [HyperCube 3D printer](https://www.thingiverse.com/thing:1752766) using the new extruder mounting system, as I couldn't find one that fit perfectly with the necessary adjustment capabilities specified in BLTouch's requirements. This design also ensures at least 2mm of clearance around the E3D V6 hotend. The mount screws into place where the inductive probe was previously located but uses a slot instead of holes to allow for some vertical adjustment, although it isn't particularly rigid. My Marlin 1.1.9 Configuration.h file is included as a reference, but don't assume it will work without modification - focus on using the probe offsets. To secure the BLTouch to its mount, I used two M3x10 screws with Nyloc nuts and washers. For my RAMPS 1.4 board, I needed to add a jumper between VCC and 5V to get the necessary 5V signal for the servo output (checked with a DMM before connecting). The rest of the installation followed standard BLTouch instructions. I recommend running the autotest sequence and manually moving the bed upwards at a slow pace to trigger the probe, ensuring it activates before the nozzle touches the bed. Once homed, dial in your real Z offset for the probe, as this value will vary greatly between users.