Bobbin for Ashford CS2 Spinning Wheel

thingiverse

I build this bobbin for a friend. I do not have a CS2, so it's untested. I based the design loosely on the S-10 bobbin I built. The CS2 is much larger, but it will fit on a 200mmx200mm print bed. The Diameter of the whorl is 190mm. The bore is 10mm, and the overall length is 290mm. Print Settings Printer Brand: Prusa Printer: Prusa Steel Rafts: Doesn't Matter Supports: Doesn't Matter Infill: 50% Post-Printing Once you have printed both end pieces, you will need to use a piece of plumbing pipe for the center. 1/2" PEX or CPVC will work. You can secure one from any home improvement store for a couple of bucks. You will need to cut the pipe to about 11" (280mm). Test fit it on your wheel before the final glueing. You may need to trim some off the pipe to make it fit.