Bog Standard Quad Drone

thingiverse

435 size quad. Print 4 legs. All 20% infill, except arms and body which are 55%. I mounted my kakute f4v2aio FC upside down so I could foam the baro easily. 1045 props, 920kv motors, betian 880 gps/mag, skyzone 3d fpv with my anet a8 extruder 40mm fan on the vtx. flysky 10 channel, modded to take analogue rssi to fc. I used 3s 3300 bat, but space for different sizes. I used velcro to stop it slipping, then strapped for safety. Cam attached with double sided foam tape. An attempt at the world record for cable ties could be on the cards. Approx 950g all in. Inav software. Print the motor spacer in tpu. Should have little gyro noise (using the kakute fc). I have noise at 50hz, but I have 1 unbalanced motor bell. Will probably edit, as looks a little bare... EDIT... Uploaded Wally and Wally(1). The camera mount was rubbish. Too much jello. This one is much better with sticky foam pads. https://youtu.be/1UNjYWGAbKc Quite windy EDIT... Uploaded new legs, GPS mount and frame brace. EDIT... Uploaded improved GPS mount and an R2D2 GPS mount.