Boltless Pi 3B+ case (3, 2 & B+ also fit) - More Cooling, Less Material Used, Printer Mounting Rail

thingiverse

I liked the original model, but it was way too thick. This remix uses significantly less material, but is still more than strong enough. The following is changed: - Scaled the width of the models to 101%. Fits quite easily this way. - Deepened the indentations of the ports by 0.5mm - Made the bottom 75% (approximately) of the case much thinner, saving material. - Added feet to the bottom of the case so the bottom of the Pi is cooled better - Added rails to the side of the case for mounting on an Ender 3 (v2) or printer that uses the same extrusion profiles - Increased the connector hole sizes to ensure that cables always fit and alignment is not a problem No bolts or nuts are needed for this case. The lid/cover is held in place by friction and the ports. The rail on the side of the case is optional, but it's ideal for mounting it on a 2020/2040 aluminum extrusion v-slot profile. This includes the Ender 3 (v2). The model with half a rail makes it possible to mount the case under the LCD panel.