Bomboniere

thingiverse

I took the initiative to develop a project for a bomboniere differentiated, ie container to put chocolates and sweets. I chose to format the design of a pumpkin, with five divisions in its interior, which allows you to put different candies and treats. The highlight of this project is for the cover system, which is the complement of the container-shaped pumpkin. The cover, upper bombonire is composed of a key that allows closing it and holding it, ie the cover itself, which has a stalk at the top and closed at the bottom to form a single set key. This set of key formed by the cap fits into the hole of the lock pumpkin, which is in the center of this. Just twist the cap on the cable, and it will close. Do not print this design on impressora3D because I'm still having connection problems with your computer. For that reason they, who can, and have downloaded the files and produced in their impressoras3D, please send me a picture so I can add to the gallery. My email is isarts3d@gmail.com.     This text was automatically translated from Portuguese into English by Google Translate. There may be some words out of context. 25/06/2013 - Analyzing the project after it was done, I found it necessary to make a small modification. Decided to increase an inch on the switch input port that is in the center of the bottom of Candies. Thus, to facilitate the introduction of this key hole because of the way it is flush with the internal divisions, the chocolates hamper this operation. Instructions The project's Candies shaped like a pumpkin consists of five files: Bottom, top and cable that forms the key. To produce it in impressora3D was nessário split parts because they do not fit in this deck. Both the bottom and the top are divided into two parts. After production of the pieces, they may be joined with superglue. Attention in the assembly of the two parts of the lid: it is necessary to insert the cable that forms the key in the center, and then unite them with superglue. Note that the key has a shoulder which is to facilitate the fitting of the two parts of the lid. Imperfections that may occur after production of parts by impressora3D can be corrected by means of epoxy putty, finished using sandpaper. In painting the set Bomboniere, will the imagination of each.