Book Stand

grabcad

My design is a book stand. This book stand is used to hold your book when you are reading. I designed this book stand because I thought it was very uncomfortable holding a book for a long period of time. I would sometimes get cramps on my hands. I also thought that if the book stand is big enough it could hold a textbook as well. To use this, you first place the book on the stand and go to the page you are reading. Then you slide the triangle so that it holds your page. Make sure that it touches the pages of the book.The 3 parts of the book stand is the slider, the slider block, and the stand. To put these 3 parts together you first get the stand and the slider. You put the slider in the small slit. The triangle should be facing up and the round part facing down. The rectangular part should go between the slits of the stand. After putting the slider in, put the slider block at the edge of the slits on the stand. The actual size of the book stand will be 2 to 3 times the size it is on the program. If I were to sell the book stand I would sell it for about 10 dollars since it very simple. If wanted they could be sold with designs on the stand. Since the parts come off, you can make different combinations of designs and colors.