Boosted Board Mini Tail Handle

thingiverse

Two handle designs for the Boosted Mini S or Mini X. Direct replacement for the stock tail puck using the stock threaded inserts to attach to the board. One is a fold-out design and the other is a simpler, one-piece design. A few screws from McMaster Carr or Home Depot are required (see parts list in Post-Printing below). The new tail puck will be a bit thicker than the stock one, so it gives the board a slightly flatter kick. The other thing I should mention is that if you’re shorter than 5’10”, I’d print the one-piece design. I’m *just* tall enough to use the fold-out handle and not have the tip of the board drag along the ground. With the one-piece handle, the bottom tip of the board is a few inches higher off the ground. For the fold-out design, the handle folds snugly against the rear truck baseplate/riser, and a detent mechanism helps keep it in place so that it doesn't come loose while riding. If it does come loose, the handle is too short to reach the ground anyway, so it won't interfere with your riding (unless you're doing tricks). See Post-Printing section below for assembly instructions and parts list. Note: Strength issues with the one-piece design have been resolved.