Boscam rx-lcd5802 Sunshield

thingiverse

I just wanted a sunshield that extended out further than the one molded on to the 5802, but did not like the cloth one they provided. I looked all over Thingiverse and found a few that people had made for other devices, but none of them ticked all the boxes for what I wanted for my Boscam. This one is a derivative of many that I saw here, but mainly is a modified version of this: http://www.thingiverse.com/thing:774161. You slide it on from the top, and the tabs hold it in place. There are holes for both of the antenna and the four plugs. Added a split version for people with smaller print beds. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator Rafts: Doesn't Matter Supports: Yes Infill: 25% Notes: Print in PETG for best results, although whatever other filament will do. Make sure you use support for the holes. I tried it without support using PLA and just could not get all the holes to print properly without it. I printed the one in the picture using PLA because I had it in black. Now I have PETG in black (but I only need one so...). Be aware, I stopped the printing on the one you see pictured about 20 minutes before it was done, so it never finished the top layers (thus you see the infill on the top edge facing you).