Bosch PLL1 P Tripod Adapter

thingiverse

Bosch PLL1 P Tripod Adapter Should fit most common tripods. Printed in ABS. See last picture for specs on D-ring screw. When mounting screw, just screw it into the plastic hole. When the threads are all the way through, it should keep itself in place. Do NOT widen the hole D-ring to much or else it will fail to stay in place. Use a very small wood screw (Ø: 2.5 mm, length 12 mm) to fasten the button to the adapter. Some modification is required for the button to get a tight fit. Originally this design was a test for 1 mm nozzle, 0.5 mm layer height, but it should print fine using .4 nozzle. D-Ring Screw for Camera Tripod can be found here: https://www.ebay.com/itm/Captive-1-4-D-Ring-Screw-for-Camera-Tripod-Monopod-Quick-Release-Plate/182566782044?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649