Bracket for RepRap Smart Controller for Cerberus Pup

thingiverse

This is a bracket that holds the RepRap Smart Controller LCD Screen at a 45 degree angle on a Cerberus Pup 3D Printer. The brackets snap in place and can easily be removed and installed. The left bracket has holes to clear the screen contrast potentiometer and although you can't see it in the picture it also clears the SD Card holder. The right bracket also has a valley to clear the solder traces on the back of the board. Instructions You should be able to print it and snap it on. You might have to enlarge the holes for the mounting screws. You will have to flip the Right bracket over before you print so the snaps are on the bed, if you print it how it comes then you will have to add supports, so just flip it around.