Bracket for Titan Aero, Reach3D Printer

thingiverse

I upgraded my extruder from the Titan to the Titan Aero, because I do a lot of flex printing. I created this model from scratch, but it was inspired by this Thing originally: http://www.thingiverse.com/thing:1977341 The Titan Aero sits a lot lower, approximately 25 mm because of the compressed design. This bracket has just enough room to clear the Gantry on the Reach3d printer. It may also be adapted to other models if needed. *** I have included the Open SCAD file. Feel free to modify for your own use/purpose! *** If you use my file for your design, please post a remix. The instructions for installing are basically the same as my remix, found here: http://www.thingiverse.com/thing:2101440 The settings in the firmware need to be updated per the above link. The prox sensor is about 10 mm wider on the X axis I believe, so that could be increased, but I haven't done that and it seems to be fine (my bed is fairly level). If I end up changing settings I'll come back and update.