brushed sparky motor mount and landing gear

thingiverse

This are a new motor mount for the Brushed Sparky. I made this because the original do not fit very good. The original was not tight enough. Also the original landing gear I could not mount because they broken at mounting. So I design a new one. The landing gear and motor mount will srew with 2 M2 screws. I make a thread in the landing gear so i don't need a nut. You can also drill the hole a little bit bigger and use a nut. there are two motormount files: one is named motormount-85: With 8,5mm hole one is named motormount-88: with 8,8mm hole I had to print with a 8,8mm hole because my printer prints the holes 0,3mm smaller. I do not know how it is on other printer so i uploaded 2 versions. The original motors have 8,5mm diameter. I also uploaded the STEP files so you can easy modify the things. Print Settings Printer: Prusa i3 Rafts: No Supports: No Resolution: 0,1 mm Infill: 25 % Notes: I printed it in ABS. Post-Printing