Budget H shifter playseat mount

thingiverse

Not my best work, not the worst. There was no mount on Thingiverse so just remixed from someone. You need six M6 30-35mm for mounting on playseat and four M6 55mm or longer for the shifter. You can use 2 shorter ones but I just used an angle grinder. Also, you might want to add something on playseat like duct tape or some rubber tape to stop it from sliding around, after torquing it's solid as a rock. As for printing settings I printed 0.3 with 3 walls and 15 infill, for clamp 4 walls, ended up 300 grams, tried with both PLA and PETG, and both works fine. Also as a bonus, you can flip it and mount the shifter on top so it sits higher, but my goal was to make it as close as a real daily car. P.S. You obviously need supports but block them for the holes, keep supports only for the part touching the plate.