Bulldog XL Mount for K8200 / 3Drag

thingiverse

This is a K8200 mount for the Bulldog XL extruder. This design doesn't require the extruder to be taken apart like others do. Note: You wont be able to use the supplied fan with this design, so this design is more suited to a hotend like the E3D, as seen in the photos. Instructions I printed with %70 infill. Choose appropriate length fasteners, the screws used to attached top mount on the Z arm may have to be cut down a bit. The bottom mount use's M5x30mm. On the bottom mount there is a Hexagonal cut out this is ideally for a 6-8mm M3 stand off. A stand-off with 5mm Across Flats works perfect, but the more common 5.5mm across flats may need to be heated up and pressed in. Failing all that you can use a M3 nut. Some faces may need some filling to fit, depending on your printers accuracy. (mine always prints a little large)