Butterfly & Dragonfly Themed Orchid Planter Set

cults3d

It's never too early to prepare for spring, and these eye-catching Butterfly and Dragonfly themed Orchid Planters can make it a little more enjoyable. Designed to be aesthetically pleasing, easy to print and assemble, it's sure to make for a satisfying project. All part models are pre-orientated in the recommended printing position. Printing the front panels in this position will result in an attractive carved/sawed-like texture that varies depending on the layer height settings used when printing. To offer versatility an optional “closed back and bottom panel” has been included in case you’d rather use these planters for a different purpose (i.e. outdoor planter, indoor planter, pencil holder, etc.) Specifications (100% Scale): Height: 5.2” (132.1 mm) Width: 5.6” (142.2 mm) Parts/Items required: Printed Parts: Note: Each planter consists of a total of 10 printed parts. Front Facing Panels: 7 pcs. Bottom Panel: 1 pc. Top: 1 pc. Back Panel: 1 pc. Items: Glue: Recommend using a Cyanoacrylate Gel Glue to help fill voids on the mating surfaces and produce a stronger bond. Small Clamps (Not Required): Used to hold the panels in place till the glue sets. Scaling: A designed clearance of .010” (2.5mm) is provided on the sides of the locating tabs. This should safely facilitate/allow printing and assembly of each planter down to as low as 60% of the original size. Please refer to the "Butterfly & Dragonfly Orchid Assembly.pdf" file for model/part identification and assembly instructions. Printing Time/Material Usage: (Printing times and material usage may vary) Butterfly Planter with open back and bottom: Printed using .6mm Nozzle, .3mm Layer Height, 15% infill @ 60 mm/s print speed Time: 9 hrs. 52 min. - Material: 143.00 grams – 45.24 meters Printed using .3mm Nozzle, .3mm Layer Height, 15% infill @ 60 mm/s speed: Time 14 hrs. 42 min. – Material: 118.00 grams – 36.73 meters Dragonfly Planter with open back and bottom: Printed using .6mm Nozzle, .3mm Layer Height, 15% infill @ 60 mm/s print speed. Time: 9 hrs. 36 min. - Material: 143.00 grams – 45.01 meters Printed using .3mm Nozzle, .3mm Layer Height, 15% infill @ 60 mm/s speed: Time 14 hrs. 15 min. – Material: 115.00 grams – 36.29 meters Credits: Butterfly Image used under license from Shutterstock.com Dragonfly Image created by: CSHughes3D