Button Cell Box

thingiverse

Small box to store button/coin cells. Holds 5 x CR2032, 4 x LR44, 6 x G3A and 3 x SR626SW. Gets them out of the normally oversized blister packs and stops them rolling around if you keep them loose in your man draw! Print with bottom of box and top of lid on bed so no need for support. Printed with a 0.4mm nozzle at 0.2 layer height. (I like to use an initial layer height of 0.28 and a 104% initial line width for good bed adhesion). Box and lid can be printed at same time. 4 top layers and 3 bottom layers. Printed with 3 walls and 25% infill (Cura cubic subdivision is strongest). My initial speed is 20mm/s then after a couple of layers is 40mm/s for infill and inner wall and 25mm/s for outer wall for a nice finish. Use a small brim only if you experience curling (the edges are quite smooth and Ididnt have a problem without brim). Your temps will be dependent on your filament but the HobbyKing Yellow am using works well with 210 degrees and a bed temp. of 67 degrees initial dropping to 59 degrees with a 100% flow). Print time approx. 3hrs depending on settings Check out my YouTube channel DonLabs for tips on electronics. https://www.youtube.com/watch?v=pS7E-TpymMc&t=1s The outside of this model looks similar to one of my other things the House Fuse Holder, check it out if you want to tidy up those pesky little house fuses.