Cable Holder

prusaprinters

<p>This print will allow you to manage cables that need to be routed across a ceiling or wall. I needed this to run cable in my garage and I did not want to crawl through the attic or chase wires through walls. With a little bit of Velcro your cables will stay put and in place, Velcro not needed but it is a nice touch!</p><p>Version 4 will allow a Ethernet Patch cable to pass through it without needed to re-terminate the cable ends.&nbsp;</p><p>Version 3 will allow thinner cables, like some HDMI cables to pass through after the cable holder is mounted.</p><p>Scale the print to make smaller or bigger versions for your needs! &nbsp;</p><p>Use can even use it on the back of entertainment centers or desks to manage those cables also.</p><p>Mounted with general purpose wood screws into studs.</p><p>**************************************************************************************************</p><p>A single Version 4 will print in approximately 35Mins on a Prusa MK3S.</p><p>Slicer: PrusaSlicer</p><p>Print Settings: 0.30mm Draft</p><p>Material: Inland Red and Black PLA</p><p>Also works well for those “left over” spools of material, simple to load more filament to finish up the print. :)</p>