Cable Management for Server Racks and Surface Mounting V2.0

thingiverse

Specific hole configuration allows multiple orientations when used zip-tied to a server rack. In addition, the hole configuration and side screwdriver opening also allow for multiple surface mounting options direct to wood, wallboard, etc using standard wood screws. Supports unnecessary with addition of new center support inside of screwdriver opening, now separated into 2 smaller openings as opposed to original single full length opening. A 200x200 bed can hold 10. A raft can be useful when using ABS and a full bed for preventing curling edges on the outer ones, in addition to providing a handy "sheet of 10" for easier distribution and shipping. This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/4n7TBFxLeG5 Print Settings Printer: XYZ DaVinci 1.0 PRO Rafts: Yes Supports: No Resolution: .4 Infill: 50% Notes: Raft recommended when printing a full bed using ABS. Different infill % will provide for different elasticity of fixed arms. When surface mounting using screws, do not tighten fully unless you are using a high % infill - leaving slightly loose works just fine. Nozzle size for resolution recommended, as these are designed to be FUNCTIONAL, not PRETTY. If you have a 1.2 with a Volcano, then print at 1.2. Post-Printing Only removal from raft, if a raft is used. If supports are used, a med/small flathead can quickly remove all of the supports. Zip-ties used for mounting to a server rack, screws for surface mounting.