Cable Retainer Clip for The Replicator

thingiverse

My Replicator came with a missing clip, did I call support? NO! This was a superb opportunity to create my very own first thingy! :-) This is a small clip used to hold down the cable that comes out from the floor in The Replicator and goes up to the heated bed. Instructions Created in Sketchup. I printed on my Replicator with 0.30 layer height, 0% infill, 0 extra shells, and a feedrate of 25mm/s. I created it based exactly on the measurements I got from the cable and hole, and thus it is a very tight fit but with 0 infill it should flex just enough to get pushed down the hole and clamp on the cable with some slight force applied. I put mine in place right off the bed before it had time to cool too much.