Caddx Turtle V2 HD Mobula7 Eachine Trashcan

thingiverse

DESIGNED FOR THE HAPPYMODEL/TRASHCAN triangular VTX. Rear VTX screw is shared with canopy mount. Camera is mounted upside down and flipped in software. Wires should exit top of camera. Designed for .3 nozzle. .15 layer height works for me, she ain't no beauty queen. Walls are .6mm so don't think you'll have much luck with .4. Definitely requires supports. TPU or other flex, canopy has to flex around front mounts to install. Requires additional 2mm hardware, I use nylon and recommend same. Requires "short" FC stack grommets as shipped with M7 V1. Tall grommets can be cut down. It's a pretty tight build so be prepared. Top standoffs should be flipped to print flat. This is a revision, original flys great but some changes hopefully make it better. Jello has been a non issue thus far. There is a small crumb I didn't clean up when I was thickening the top... sorry bout that.