Caddx Vista Conversion for Diatone Rabbit R349

thingiverse

A super simple way to mount a caddx vista & DJI camera to the diatone rabbit R349; note that the original stack has been replaced with a geprc 20A aio flight controller. This 3d-printed components of this project consist of three-parts: 1) A mating plate for installing the aio board on top of the caddx vista (_not_ decased, though you probably could do so if you wanted) 2) a front spacer to make room for the DJI camera and AIO board under the canopy 3) a rear spacer & mount for the vista antenna A few additional thoughts: -the mating plate has holes for m2.5 nuts (it's been a while- check once you print) -- cleaning support material out of these holes prior to assembly is pretty important -to install the dji camera you'll need to cut some more space in the front of the canopy to make room for the lens. It should be obvious. The camera itself is a pretty snug fit, but I've glued it in place with liquid electrical tape! -don't forget to have fun!