Cagiva Mito Crank shaft press tool

thingiverse

This is a tool when you rebuild the crank shaft. This is made for the Cagiva Mito 125ccm. It is just a cylinder that is used when you press your crank shaft. First you press the Big end con rod pin into one of the sides of the crank. Then you place this half into the sylinder. Then assemble the bearing for the conrod and the conrod. Then you place the next crank shaft half in the top of the cylinder and press. the hole in the side is for the conrod. This cylinder helps holding and line up the parts while pressing. It is only for one time use and I just brake it open when used. It worked perfect for me and the alignment of the axle was less than 0,02 millimeter of so I did not need to true the shaft after