Calibration Quoob(yes, another calibration cube thing)

prusaprinters

<p>Well, this is my shot at designing an interesting calibration cube. It's got some easy bits, and other bits are slightly evil, but here is the list of features:</p><p>25mm size in xyz, with size markers for z and x/y(depending on which way you decide to orient it)</p><p>Awkward corner overhang/bridge at the meeting between the logo and chamfer</p><p>The inset numbering to give the printer a bit more of a challenge than just a slight overhang in the x and y of most calibration cubes</p><p>small bed contact area to test adhesion</p><p>large bridge in centre hole to test bridging</p><p>relatively thin walls to test gap fill and solid infill settings, as well as exaggerating overextrusion issues if present.</p><p>Top corner chamfer produces a very thin wall section to test cleanliness of thin extrusions</p><p>&nbsp;</p><p>To exaggerate the appearance of flow imperfections, use a grey filament under harsh lighting</p>