Caliburn - Reinforced Ayy Lmao Grip Panels

thingiverse

NOTE: This only contains the left and right panels, go to the original Ayy Lmao post to get the center piece/trigger guard. I reinforced the Ayy Lmao caliburn grip around the threaded rods, as previously it was thinner and weaker, with decorative holes. The walls are now a similar size to the Monolithic grip's threaded rod area. I did this as I plan to hip-prime a K14, so I will need a strong grip. The layer orientation on this grip makes it favourable for that use, and the reinforced threaded rod holes should make it less likely to shear off if torqued horizontally when priming. I printed this at 7 walls and 70% infill with 6 top and bottom layers, although this is wildly overkill, I figured that if you do it at all, you may as well do it the best you can.