Cameo 4 - Heat Active Pen Holder

thingiverse

This is a holder to use in the Cameo 4 the "Heat Active Pens" from "Crafts & Co." - I think these are the same pens that used to be in the Action Market but can't guarantee it as I didn't get any. It may also fit other pens of this design. <b>Since the parts are very filigree, ABS-Like-Resin printing is recommended!</b> The Jig to adjust the distance of the pen tip is identical to that for my <A HREF="https://www.thingiverse.com/thing:5242792"><b>Multi Pen Holder for Camero 4</b></A>. If you are already using this, you do not need to print it again. However, since it is a bit more complex to use these pens than a normal pen, I recommend printing a separate holder for each Heast Active Pen and leaving it in it. <b>Please keep in mind that the tip of the pen gets very warm. (I measured mine at around 120°C (248°F)). It is best to only insert it after it has warmed up, directly before using it, and then immediately remove it from the tool holder – or you can get a metal sheet that you place under the pen to protect the cutting mat when it is not working. But I would recommend really only putting them in the plotter for the time of use and putting them on a heat-resistant surface the rest of the time!</b> What else you need: * Hex nut M3 (DIN 934) * M3 x screw 8 or 10 mm or longer (I used: M3x8 mm (DIN 912)) * Aluminum sheet 14x10x0.5 mm (ONLY if you want the automatic tool recognition (from the blue adapter, or get a 0.5 mm sheet and cut it to size)) <b>Please note that these are not original Silhouette accessories, so using them can invalidate the guarantee. Use is at your own risk.</b>