Camera Lens Cap Holder

thingiverse

A little redesign of the cap holder after some suggestions of my father :) Hoping to making it simpler and more practical. The bottom and perfectly flat face will hold the cap, even more, thanks to a sort of lip like the original thing (due to the first layer being usually more squished than the next ones); while the support, once removed, will leave a sort of grip on the attach. Supported diameters : 40.5-77mm for the common known diam. (52mm in the pictures) (If you wonder about the file name: "s" mean "support", because the initial versions were without; while "p" is for "pente" because the side is not straight for a more pleasant contact when grabbing the cap. Here is also a 80sec. making-of the 49mm holder http://youtu.be/jQms74oR9hY ) Instructions Before print : 1) Set skeinforge for two shells and low infill, or even better if filled with shells and zero density nor solid surface to make a more flexible attach (like 15 extra shells) 2) Enable support (e.g. : Interface feed 2.0, flow 0.9, density 0.10-0.15, LTOLT 0.5, layers 0, lift 0.25; Support flow 0.7, gap 0.5, exterior only). After print (10-20min) : 3) Remove support 4) Just slide it on your strap, shirt, or anywhere else :)