Camera mount point for Tenlog TL-D3 Pro and variants

thingiverse

I created this camera mount base piece to mount a camera on my Tenlog TL-D3 Pro using the diagonal vent slots in the base of the printer. Printing requires supports, and you will need to do some cleanup after removing the supports. The screw in the base is not supposed to thread into anything, except the part itself, therefore the hole for it is tight on purpose. The part that slits into the vent hole need so slide in freely, it is not supposed to get stuck in there. Once slid in, twist carefully to clamp it, then screw in the screw a little further to prevent accidental loosening and pivoting of the camera mount. This part is meant to be used with this set of struts; https://www.thingiverse.com/thing:5233217 And for a night-vision camera you can use the camera housing found here: https://www.thingiverse.com/thing:434600 For an original RaspberryPi Camera Module, you can use: https://www.thingiverse.com/thing:2886101 I also found this one: https://www.thingiverse.com/thing:4227360 Final note; please excuse the poor print quality. I tried printing with custom supports on part of the model only, did not work out well, but the part still works and I hate wasting plastic, even if only 2 grams :) Also, I used an M3x20 bolt instead of x16, because I was too lazy to get a shorter one. The bolt that goes into the printer is an M3x6, ideally you would use M3x5 or M3x4 as the sheet metal of the printer is 1.5mm (more or less) thick. I used the before last slot as the last slot has the power supply in the way, and yes, the screw touches the PSU, which is why I suggest a shorter bolt :) I only have had this printer for a week so I am still in the process of designing all the parts to print, and this is the first :) Enjoy!