Camtono Star Wars Mandalorian 6"

thingiverse

Update 11.09.20: Sorry, I Made a mistake while uploading the Files. You have to mirror either the lock or the flaps before printing or else the lock wouldn't Work if you have downloaded the files earlier, or you download the new flap which I have corrected now. (The little hooks in the flaps were to the wrong Side) Legal stuff: BY DOWNLOADING THE FILES FROM THINGIVERSE YOU AGREE TO THE FOLLOWING TERMS AND CONDITIONS: The files are for private use only! You are allowed to print parts from them for your personal use only! You are not allowed to use this files or parts you printed with the use of this files of it in any comercial way! If you are distributing Pictures from parts or models you build with theses files you are only allowed to to so if you are declaring the source of the design. You have to add a link to this thingiverse-thing in the description of your Fotos! You are not allowed to copy or distribute them in any way! You are not allowed to sell them or parts you printed from them or models you build with the use of this files! Description: "Such a larg bounty for such a small package" "Buy yourself a camtono of spice" "This is the way" This is a Camtono from Star Wars as seen in Episode 3 season 1. Its fully operational, all 3 flaps can be opened and locked by turning the upper lid. Scale is for 6" figures but you can scale it to 200% for 12" HotToys figures. Also I added some beskar pieces to fill it. Scaling down to 66% for 3.75" figures is not recommended as the hinges are very small and sensitive even at 6". This is a very small thing, but nevertheless took me some time to print and optimize, so drop me a like and consider giving me a tipif you love the design. Thank you. Printing: Print at highest quality: 0.1mm layer are highly recommended. The parts are oriented in the right direction to print, don´t turn them. For the body you need supports, set to "touching buildplate". Removing them after printing is difficult, so take your time so that you don´t break the body. I recommend to split the support in the middle with pliers and carefully lift it with a small screwdriver and pliers. I set the layer between support and part to 0.2mm, which makes it somewhat easier. I found the surface over the support a bit rough, but thats just fine as it looks a little bit like carpet on the bottom of the camtono, which fits fine. The rest of the parts are very easy to print. Assembly: See the picture for reverence. Inserting the door through the openings on the side is a little bit like a puzzle. Clue the lid to the lock, but not to the body, as lid and lock should be turned to lock the flaps. Use a 1mm diameter wire and cut three piecess of 9mm for the hinges. If you have problem getting them through the holes or if they are not printed open heat a thin needle over a candle and carefully! open them with the hot needle.