Canard Nose for GASB-1

thingiverse

An even longer nose section with a small LERX where it meets the other wing sections, and it has flat sides and a pass-through hole intended for a rod which links to canards. Right now it's a WIP as it likely needs some revision (interior bits), but I figure this much is a start. Based partially on the revised nose section, but manually remeshed since some things are easier in Blender when working with quads instead of tris. On top of all that might have to split the nose piece into two sections to make it easier to print. I suppose this could be used to build a GASB-1.5? (Since it adds a GASB-2 feature with a part intended to fit the rest of the GASB-1.) --- Edit --- Added the file for a basic canard airfoil piece. Should be mirrored for the other side. Also keep in mind the hole is offset a bit towards the front. (Likely less stable if installed backwards.) I figure this size should be adequate for some good control authority (it's the moving plane type), however (as is the nature of this) you're free to try bigger or smaller ones. --- Edit --- New version of the main file. First version didn't have the little catches for the cover piece. This one should correct that.