Canon HFS10 to Slik tripod mounting plate

thingiverse

"Slik" brand tripod quick release plate to allow opening of the SD card door on a Canon Legria HFS10 camcorder. Print Settings Printer: DIY Frankenprinter Rafts: No Supports: Yes Resolution: 0.25 Infill: 35% Notes: Scale it up by 1.02x for ABS to allow for shrinkage. Usually this can be done in the slicer. I printed it in the orientation that it is here, i.e. "upside down" to the way it would sit on the tripod. Supports are a must in either orientation but this way up it leaves the tripod mating surface clean and the part the camera sits on will also be as smooth as your print surface (which in my case was glass). Post-Printing After removing all the supports and cleaning it up, you may wish to glue a piece of rubber or other non-slip material (felt, carpet, silicone mat) to the part the camera sits on, just to stop it sliding around.