Canopy for Spark v3

thingiverse

There's 4 different designs and 2 angles for each design. canopies with "aio" in their name fit the Sparkv3 for AIO boards. Canopies with "16" in their name fir the Spark v3 for 16x16 stacks. Canopies with 10mm in their name fit 10mm lenses (caddx ant, whoop cameras, etc) canopies with 12mm in their name fit 12mm lenses (runcam nano 2, eos2, etc) there's two different angles: 35-40 and 45-50 degrees. Once the canopy is mounted to the frame, you can adjust the rear standoff higher or lower to adjust the up tilt as needed. I print them upside down with 100% infill. I use 95a or 98a tpu (more firm than other types of tpu) So, I don't need support for the 45-50 degree canopies. If using the lower angle canopies or using more flexible tpu, then you only need supports around the front part of the canopy that mounts to the frame.