Canto Bight Police Officer Relby K-25 Blaster

thingiverse

I'm excited to share the side-arm blaster of the Canto Bight Police Officer, the Relby K-25. This short configuration is intended to fit in the belt holster of a Canto Bight Police Officer. There are larger configurations coming soon, but we'll start with this holstered beauty. I'll be putting together an official build guide soon, but this piece will have full electronics with lights and sound. 5mm red LED lights should fit nicely in the 3 holes on each side, as well as the tip of the barrel. 3mm red LED lights fit into the side tubes. I've engineered the inside to have a spring-snap trigger and pegs to screw the micro-processor, sound chip, amp, and back-pack chips as well as cut-out areas for a speaker and re-chargeable battery. Make sure all of your electronics work before you completely seal it, because by design... you'll be screwing it together and gluing it shut. I've made the barrel an insert-and-lock piece, so bigger configuration pieces can be interchanged. Just slide it in and turn it to keep it in. One thing to note... when you print the right and left sides, the side tubes will not print. Pull off all of the fill-material and crud, and then add the side tubes included with this model. That way, you'll have an easier time wiring the side tubes later. I could never get the ones on the right and left side to print correctly, so I modeled them separately. Enjoy!