Card Carousel

thingiverse

Created this after looking at some of the other ideas that were on here (and even printing some with less than stelar reviews by the people who I gave it to for testing. So after my experiment I decided to just start over. This is intended to be used with a 608 bearing pressed into the hole beneath the carousel itself. I would start by pressing it onto the base then press the two into the carousel itself, your call which will work best for you. It shouldn't take much pressure at all. I would printthis at 30% bare minimum infill for the top piece, at least if you are going to press the 608 bearing in with a vise like I did.