Carrera Go to 1st First Track Adapter

thingiverse

This is a Track Adapter to allow two different types of Carrera Go Track to connect together. It allows for the wider track to connect to to the narrower track. The only edition you will need is some sticky back copper tape which is readily available on Ebay, alternatively you may be able to use tin foil but would need to find some method of sticking it down. I ended up using wider copper tape and making it go over the ends a bit more to make a good electrical connection. I would suggest printing this with supports as the connectors and openings need it. I did not put a roof over the smaller connector holes as it was too difficult to remove the support material. I have thoroughly tested this model and it works great. Please not you will need to print at least two adapters. I would suggest removing the controller box from the secondary track as I found that with it part of the track even without batteries in it caused both cars to be controlled by one controller, its very simple to remove the block from the track if needed, or just don't use that piece of track.