Case (fits straight edge razor)

thingiverse

This is a two part case designed for objects .393" X 1.102" X 5.709" (10mm X 28mm X 145mm). The sides of the base and cover are sloped towards drain holes. When stood up on the base there is also a sloped surface leading to drain holes. This was designed for a Parker SR1 Stainless Steel Straight Edge Barber Razor, but should work with anything which fits inside. This is my first time designing a snap fit case. By design the bumps should take some pressure to close, but once closed should be snug with no movement between the cover and the base. Conversely it should take some pressure to pull the cover off the base. For the first print the cover was a bit to tight to put on. I whittled the first nub off the cover and it worked fine. I'll find some time to optimize the cover to make it easier to put on/off.