Case for 1/3 inch Sony CCD camera

thingiverse

This case is for the Sony 1/3 inch open PCB camera. It covers the entire front, and snaps in place. There are two versions, a curved and a compact one. There is also a version with an extended skirt that also protects the rear PCB when it is mounted on a flat surface with suitably sized spacers. The image shows the compact one with skirt, mounted on a simple pan/tilt device. The OpenSCAD file should allow easy tuning of most parameters. Instructions The curved versions builds from the bottom, and can be tricky to get to build nicely without supports. The more compact version builds from the top, and should build without much problems. The extra edge along the bottom of the rounded case is to make it stick better: it can be cut off after printing.