Case for DSO 062 JYE Tech Oscilloscope

thingiverse

This is an inspired mashup from a couple things noted below, but made to fit my JYE Tech DSO 062. Redrawn from scratch. You can pick from a plain bottom or one with a kickstand. To attach the kickstand, insert a piece of 1.75mm filament for a hinge pin. On mine the filament fit well, but there's room for a spot of glue inside if you need it. Instructions Print it ! Slip the kickstand into the slots in the bottom if you opt for it. Slide a 1" or so long piece of filament through the hinge pin holes for the kickstand to pivot on. Remove the bottom PCB cover plate from your DSO 062 and keep it for a cold beverage coaster from now on. Feel free to take a sip at this point. Replace the PCB bottom plate with the bottom half of the case, using the same 4 screws to fix it into position. Remove the top plate of your DSO 062 and keep it nearby. Slip the top of the case into position. Screw the top plate back onto your DSO 062. This clamps the top of the case to the bottom, and you're done. A tidy DSO sandwich to go with your drink.